The task of cutting insulating materials is one of the most time and labor consuming tasks in duct manufacturing.
- Cutting insulation by hand is the slowest process in making duct;
- The equipment for waterjet cutting is very expensive you have to recycle or purify the waste water, which further increases the cutting cost, and your insulation material gets fairly wet, complicating the assembly operation and the manufacturing process;
- The plasma cutting of virtually any insulation produces very toxic fumes;
- The router generates an enormous amount of dust particles, creating a health hazard, and in case of the fiberglass-based insulation, this hazard can be life-threatening.
The VapoJet process is based on using a jet stream of a high-pressure water vapor produced at room temperature by a specially designed jet attachment.
VapoJet can be mounted on its own cutting table, or can be used on the same gantry with the plasma torch.
The VapoJet process is safe, clean and simple, and it offers all the advantages of waterjet cutting at a fraction of the cost. Our PractiCAM software fully supports the VapoJet liner cutting operations in every equipment configuration.
The VapoJet process is safe, clean and simple, and it offers all the advantages of waterjet cutting at a fraction of the cost. Our PractiCAM software fully supports the VapoJet liner cutting operations in every equipment configuration.